An iced-up outdoor unit or lukewarm air points to a fault
In winter a heat pump frosts over and then clears itself every so often. That is the defrost cycle. A bit of steam coming off the outdoor unit, or a short pause in warm air, is normal. Some things are not normal: a coil that stays white, a solid block of ice building up under the fan, or a unit that runs for hours while the house loses a degree at a time. Other signs that a part has failed are lukewarm air from the vents on a mild day, an outdoor fan that won't spin, a breaker that keeps tripping, or grinding or rattling from outside.
The usual causes are a failed defrost sensor or control board, a slow refrigerant leak, a seized outdoor fan motor, a clogged filter starving the indoor coil of air, or a reversing valve stuck in one mode. On a hybrid system, check whether the gas furnace is still heating the house. If the furnace has stopped too, that is the urgent part, so see furnace repair and call us. If the furnace is still keeping the house warm, you can book a visit for the heat pump.
Snow around the outdoor unit is the first thing to check
Environment Canada's 1991 to 2020 climate normals for Egbert show about 174.1 cm of snow a year, falling on roughly 57 days. An outdoor unit sitting on a pad at ground level gets buried. Once the coil can't pull air through, the heat pump can't make heat. Water from the defrost cycle also needs somewhere to drain. If a drift blocks it, it refreezes into the base of the unit and can lock up the fan.
After a storm, brush the snow off the top of the unit and clear the sides and the space underneath with a broom or by hand. Don't chip at ice on the coil, because the fins bend easily. If ice has jammed the fan, switch the unit off at the outdoor disconnect and call. On a new installation we set the outdoor unit on a stand or wall bracket above where snow usually piles up, and away from the drip line of the roof.
If you also have a newer side-vented furnace, clear its two plastic pipes while you are outside. This guide explains why.
In a hybrid system the gas furnace carries the coldest nights
Enbridge supplies gas in the Township of Essa, and many houses here already have a gas furnace. For those houses a hybrid system is often the sensible choice. A cold-climate heat pump handles spring, fall and much of the winter, and the furnace takes over below an outdoor temperature you choose. Egbert's January nights average −11.3 °C at their lowest, and the record is −35.5 °C, set on January 16, 1994. A heat pump puts out less heat as it gets colder, but a furnace doesn't. With both, the house stays warm on the worst night, and you don't have to buy a heat pump sized for a temperature that rarely comes.
The most common complaint about hybrid systems is the point where heating switches from the heat pump to the furnace. If it is set too warm, the furnace does most of the work and the heat pump earns little. If it is set too cold, the house cools off while the heat pump struggles. We set it for the house and your gas and electricity rates, and show you where the setting is so you can change it. Work is performed by TSSA-certified gas technicians. Gas connections and venting follow the CSA B149.1 Natural Gas and Propane Installation Code.
If there's no gas line, or you would rather give up gas, a cold-climate heat pump with electric backup heat can heat the house on its own. We size it so the backup heat runs as little as possible.
The house decides which heat pump fits and where it goes
Houses built from the 1990s onward in Angus, Thornton and Baxter usually have ducts sized for central air. A ducted heat pump can take the old air conditioner's place and work with the existing furnace. The married quarters units around Arras Road at CFB Borden are different. They were built in the 1940s and 50s with small ducts and no plan for air conditioning. Pushing heat pump airflow through ducts that small makes the system loud and leaves the far rooms short of heat.
Houses built before 1945 were heated with wood or coal, and their ductwork was added later. Upper rooms often get weak airflow, like the back bedroom over the kitchen that never quite warms up. In those houses, ductless indoor units in the rooms the ducts don't reach, or a ducted system with some runs rebuilt, usually works better than one large unit. Our air conditioning installation page covers the same choice for cooling.
Sizing starts with a room-by-room heat loss and heat gain calculation. Where the work needs a building permit, the Township of Essa's application checklist asks for heat loss and gain figures, so the same calculation serves both purposes.
How a heat pump installation goes
A technician comes to look at the house: the ducts, the furnace, the electrical panel and where the outdoor unit can sit clear of snow and drips. Then you get a written price, with options where they make sense, such as hybrid or all-electric and ducted or ductless. Nothing is ordered or fitted until you approve it.
Heat pump rebate and incentive programs change, and some require an energy assessment before the work begins. We check which programs are open when we quote and tell you what paperwork each one needs, so you don't lose a rebate because steps were done in the wrong order.
On installation day, work is performed by 313A refrigeration and air conditioning mechanics. The refrigerant lines are pressure-tested and evacuated before the system is charged. Then we run the system in heating and cooling, test a defrost cycle and set the controls. Register the equipment with the manufacturer and keep your service records. Manufacturers can ask for both before honouring a warranty claim, which is one reason to book regular maintenance.
The same unit cools and dries the house in summer
A heat pump is also your air conditioner. The Egbert normals put July's average daily high at 26.0 °C, with relative humidity averaging 88.0% at 6 a.m. and 64.0% at 3 p.m., so taking moisture out of the air matters as much as cooling it. An oversized unit cools the air quickly and shuts off before it has removed much moisture, and the house stays clammy. That's one more reason sizing starts with the heat gain figures. If the system isn't cooling, is icing or is leaking water in summer, see air conditioner repair.
