A hot, sticky upstairs is usually a duct problem before it is a size problem
The complaint we hear most in July is that the main floor is fine and the bedrooms upstairs never cool down. In a lot of Essa houses that is the same bedroom that never warms up in January, and the reason is the same. Not enough supply air gets there, and the air has no good way back to the return. A bigger air conditioner does not fix that. It cools the main floor faster, shuts off, and leaves the upstairs warm and damp.
Other signs point to the whole system rather than just the outdoor unit. Rooms feel cool but clammy, the outdoor unit runs in short bursts, air whistles through small registers, or the basement smells musty all summer. If the air conditioner you have now has stopped cooling, is icing up or keeps tripping the breaker, start with air conditioner repair and get the house cool again. Planning a new system can wait until then.
Older Essa houses were not built with cooling in mind
Before 1945, houses in Angus, Thornton, Baxter, Ivy and Utopia were built for wood or coal heat. Most were later converted to oil and then to gas. The ductwork in these houses was added after the fact, and it often has long runs and weak airflow to the upper rooms. The village core in Thornton is among the oldest housing in the township, and many of its houses are like this.
The married quarters units around Arras Road at CFB Borden were built in the 1940s and 50s with an oil or early gas forced-air furnace, small ducts and no plan for air conditioning. Cooling needs more airflow than heating does, and a cooling coil on top of the furnace adds more restriction. Push central air through those small trunks and branches and you get noise, a coil that frosts, and rooms that stay warm.
None of this rules out cooling an older house. Sometimes a larger return or one new branch line to the upstairs is enough. Sometimes ductless is the better answer. If you're not sure what you have in the basement, our guide to Essa furnaces walks through the common setups.
Newer houses usually have the ducts but need them balanced
Houses built in Angus, Thornton and Baxter from the 1990s onward usually came with a high-efficiency furnace vented through the side wall, central air and often a ventilation unit. The ducts were designed with cooling in mind, which makes replacement simpler. The common issue is airflow that was never balanced, so a bonus room over the garage or a back bedroom runs several degrees warmer than the rest of the house.
A new outdoor unit has to match the indoor coil and the furnace blower, and the blower speed has to be set for cooling. We check that pairing and adjust the dampers where the ducts have them. If the furnace itself is near the end of its life, see furnace installation and replacement before you decide.
Sizing for the damp matters as much as sizing for the heat
Summer in Essa is short, but it is humid. Environment Canada's 1991 to 2020 normals for Egbert show a July daily high averaging 26.0 °C and about 9 days a year above 30 °C. Average relative humidity is 88.0% at 6 a.m. and 64.0% at 3 p.m. An air conditioner removes moisture only while it runs long enough for water to collect on the coil and drain away. An oversized unit cools the air quickly and stops before it has dried it, so the house reaches the set temperature and still feels clammy.
That is why we size from the house and not from the label on the old unit. A room-by-room heat gain calculation looks at windows, insulation, which way the house faces and how the rooms are used. The Township of Essa building permit checklist asks for HVAC details, including heat loss and gain calculations where they apply. The same numbers also show which rooms your ducts can serve and which they can't.
Ductless systems fit where the ducts can't carry cold air
A ductless system puts slim wall-mounted heads in the rooms that need them. Each head is linked to an outdoor unit by a refrigerant line that goes through a small hole in the wall. It suits the top floor of an old farmhouse, an addition the ducts never reached, or an Arras Road unit where enlarging the ductwork would mean opening up walls and ceilings.
Most ductless units are also heat pumps, so the same heads can provide heat in spring and fall and take some of the load off the furnace. See heat pumps if heating is part of the plan. Egbert's normals show 174.1 cm of snow a year, so we mount the outdoor unit on a bracket or stand that sits clear of drifts and out from under the roof edge.
How an installation goes from first visit to a cool house
On the first visit we measure the house and look at the ducts, the furnace, the electrical panel and where the outdoor unit can go. The outdoor unit needs a spot away from roof drip lines, the dryer vent and the side-wall furnace pipes. We then give you a written price for the options that make sense, such as central air, central air with duct changes, or ductless. Nothing is ordered until you've approved one. Where a permit applies, we prepare the HVAC details it asks for.
On installation day we set the pad or stand, run the line set, the condensate drain and the electrical disconnect, then pull a vacuum and check the charge. Work is performed by 313A refrigeration and air conditioning mechanics. Where the furnace has to be opened or its gas connections disturbed to fit a coil, work is performed by TSSA-certified gas technicians. We finish by checking airflow and temperature at the registers and showing you the thermostat and filter.
Register the equipment with the manufacturer and keep the installation paperwork. Manufacturer warranties often depend on both registration and a record of regular service, and seasonal furnace and AC maintenance gives you that record. When you're ready, ask for a quote.
